Product Description
Owns two national patents the thermal-transmission bright fixation.
1.On the fabric medium principle diagram as follows:
One Two
The working principle of machine is figure one;
Single principle is figure two.
The machine features: 2.1 Bright fixation cheaning machine;
2.2 Natural swing type tension roller unrolling and rolling.
2.3 Can be single complete inkjet printer spray finishing unheated light work and can be used in conjunction with the inkjet printer;
2.4 Used in conjunction with the photo printing machine, speed can be 22～30 square meters.
2.5 Work with the single machine speed can be faster;
2.6 Detachable split package;
2.7 The thermal-transmission bright fixarion GU1900 and GU3200;
2.8 Inkjet printer printing width of 1.6M～1.9M can be installed GU1900;
Operation steps: 3.1 Install the power line ground wire and the provided;
3.2 Start the main power switch;
3.3 The heating switch, adjust and set the temperature control table shows the heating medium heating temperature, when the temperature control table shows the temperature reaches the preset temperature, and then start the fan purifying switch;
3.4 Purification activated switch, temperature is maintained at a preset temperature, start unreeling switch will switch to the left(clockwise)position and start winding switch, at the same time inkjet printer can begin to work;
3.5 Pull switch is not started, the switch is a natural pull guide roller switch, the total power switch starts with natural tension roller natural to start work;
3.6 Heat drying fabric finish baking work after the winding switch is closed, the unreeling the switch to the right(inversion)position, make the roll to roll the remaining motor reversal fabric wrapped around back to the tape guide roller guide roller, to prepare for the next work;
3.7 The remaining fabric wrapped around after the roll switch to the middle(stop)position;
3.8 The fan purifying switch off, at the same time, temperature control meter adjusting temperature was set at 240℃;
3.9 When the temperature reaches the set temperature of 240℃, keep 20～25 minutes after opening fan purifying switch, the biggest fan air volume, 15～20 minutes later, the heating temperature control table is adjusted to the first when the temperature settings, close the heating switch and then, 20 minutes after the closure of fan purifying switch;
3.10 Turn off the power switch;
3.11 The control switch power line off the power;
3.12 Maintenance free:When the body temperature or line with the environmental temperature, the heat oven, open, with a rag to wipe clean the inner wall heat oven residual oil, and then hot oven Nagato shut, to prepare for the next use;
Objective:In order to use in the next time process inside the body does not have oil falling off in the heat drying fabric, affecting the quality of products and related fabrics and other materials of the invisible waste;
Matters needing attention; 4.1 Machine failure needs repair, must the emergency stop button is pressed, cut off the power before repair!
4.2 Equipment in use process, banned the use of oven, open, to avoid excessive heat to burn on the limb;
