Application: Tablet PC Lift control POS terminal Parking system Access control Handheld terminal Attendance application Recreational Machine Barrier gate/rapid-open gate Module NO: Module NO. | Interface |
OM-HM211-WG | Wiegand26/34,5V |
OM-HM211-T | TTL,5V |
OM-HM211-S | RS232,5V |
OM-HM211-H | USB-HID,5V |
OM-HM211H-WG | Wiegand26/34,9-12V |
OM-HM211H-S | RS232,9-12V |
Parameter: Frequency | 13.56MHz |
Standard | ISO14443A |
Supporting Cards | Mifare s50/70,F08,ultralight,ntagCard |
Interface | Wiegand26/34, TTL,RS232,USB-HID |
Power Supply | 5V,9-12V |
Card Reading Distance | 0~6cm(Depending on label size) |
Current | |
Operating Temperature | 0℃~55℃ |
Antenna | built in |
Dimension | 45*25*6mm |
The IC card reader can set five output format steps:
1. Use IC card to set output format, such as IC card number (called A card): B5 BB 23 FE (opposite to the UID read by NFC mobile phone software, we call it reverse order, and vice versa.)
2. The IC card is not detected within 1 second after power-on, and the setting fails. The card reader output is the card number in the current format.
3. If the IC card is detected within 1 second of power-on, it will enter the setting state (it is better to put the A card in the card reading range of the card reader for power-on). At this time, the LED light will flash continuously (about 5 seconds). Please start setting within this period.
1) Swipe another IC card (called card B) once, and then swipe card A again or wait for 5 seconds. The card reader is successfully set, and the output IC card number is the 10-digit decimal reverse sequence: 3048940542 (8H10D, take 4 bytes to 10 digits)
2) Brush the B card twice in succession, and set the output card number to 8-digit decimal reverse order: 12264446 (6H8D, the last 3 bytes are converted to 8 bits)
3) Brush the B card three consecutive times, and set the output card number to 8-digit decimal reverse order: 18709214 (2H3D4H5D, the second byte turns to 3 bits, and the second byte turns to 5 bits)
4) Brush B card 4 times continuously, and set the output card number to hexadecimal reverse order (8H or 14H): B5 BB 23 FE
5) Brush B card 5 times continuously, and set the output card number to hexadecimal positive sequence (8H or 14H): FE 23 BB B5
4. In the configuration mode, swipe the third IC card (called C card), and the card reader is set to not carry the carriage return.
5. In the configuration mode, swipe the A card again to confirm to exit the configuration