Chemical Requirements: Analysis on cast. To be in accordance with table below Required | For Information only Recomme ndation |
C | Mn | Si | P | S | Cr | Mo | Ni | Al | H |
0.43/0.50 | 0.60/0.90 | 0.15/0.35 | ≤0.025 | ≤0.025 | ≤0.020 | ≤0.06 | ≤0.25 | 0.02/0.05 | ≤2ppm |
Note: P+S: 0.04 max, Cr+Ni+Mo≤0.63. |
Mechanical Properties Required : On material at the time of supply. - Sampling: Material shall be test per heat and per heat treat load, once Tensile and Three impact. Test practice in accordance with ASTM A 370-10 and ASTM A-434 CL BC, test specimens shall taken with the longitudinal axis located at 1” bellow surface. Surface | Yield/Re 0.2% offset | Tensile/Rm | 2” Elongation | Area Red. | Charpy V | Note |
BHN | Mpa | PSI | A % | Z % | Ft-lbs | 1KSI=6.895MPa |
150-210 | 305 | 590-720 | ≥16 | ≥45 | 21 J | 1ft-lbs=1.356J |
Report 0.6% eul for inform only | | | | | |
25.4 MM sub surface cheking at least 4” or 102 mm from end of bar: 285-360BHN, aiming for 285-302BHN |
General requirements: Forging reduction ratio:≥4:1 Austenite grain: As per ASTM E112-latest, grade 5-8 Guarantee no crack, no flake, no shrnk hole, no pin hole Mercury free: non radioactive, no welding. Decarburization is allowed for the RT and then QT bars. Non-metal inclusion: As per ASTM E45-latest method A Surface condition: rough turned, required a surface finish of 500 RMS or better End hole: removed the ends holes. Dia. Tolerance: -0/+2mm. Out of roundness: within 1.9 mm. Straightness: max. 2mm/m.:≤1.9mm, 2mm/m. Forged Bars surface grinding allowed, Must not remove surface bellow nominal diameter. Material shall be untrasonic tested in accordance with ASTM A388 4mm FBH. Austenitize @1575-1625°F, 45 minutes per inch. Temper @900
°F min, 60 minutes per inch.