Feature
The product is one kind of sulfur silicone sealant with one acid component which could be applied at any climate and could take chemical reaction with the water in the air rapidly. Good aging-resistant ability, high flexible, perfect performance of high or low temperature resistant.
Main Composition
α , ω -Dihydroxyl Methyl Silicone
Scope of Application
This product used for gear case, fore-and-aft board, water pump of car, auto bike, plane flange, cover board of other machine equipment.
Using Method
1. Clean the surface to get rid of the rust, oil, or any dirty.
2. Stick temporary band to protect the surface after cleaning, and move the band off after applying of the glue.
3. Cut the bottleneck and fix the nozzle on, then, cut the tube along the seam width.
4. Extrude the glue on the place to be sealed after fixing the glue bottle on the gun. To promise the glue to be even and no stopping, keep the extrusion continuous and the nozzle of the spray gun move slowly. Bubbles or holes would enter if the gun moves too quickly.
5. About 15 minutes later, to be dry. Keep the thick during assembling. Would set after 24 hours at normal temperature.
Warning
1. It is not preferred for the applying at the air-tight situation. Keep ventilative during the operation as the acetic acid is released due to the chemical reaction.
2. No toxic of product. But be careful not to make the glue get into the eyes or nose. Wash them at once if does.
3. Keep smooth and continuous during applying of the glue onto the sealing surface. The adhesive performance would be not good if the air get in.
4. Tighten the lid at once and take off the extrusion nozzle after gluing to avoid entering of the wet air and causing of the solidifying. Eliminate the remnants around the nozzle.
5. Operate at 5-40Centigrade and humidity of 40-80%.
